Screen Image
|
|
Explanation
|
- Either the front, rear or both crane bases are angled beyond acceptable limits
|
Causes
|
- Damaged sensor cable or connector plug
- Moisture in sensor connecting plug
- Faulty sensor
|
Operator Actions
|
- Check trailer is parked on level ground.
- Check connector plug firmly seated and not damaged
- Check sensor has not come loose
- Use override code to continue operation
- Request service
|
Service Tasks
|
- Park the trailer on level ground and go to VIEW SENSOR VALUES then VIEW FRONT (or REAR) ANGLE SENSORS
- The trailer camber and elevation angle sensor readings should = 0 degrees
- If not, then first check that the angle sensor has not come loose before recalibrating using procedure SL0005
- If the recalibration fails then check the wiring before replacing the sensor.
- Remember, all angle sensors are the same component so it is possible to swap sensors in order to help diagnose faulty wiring or a faulty sensor. Remember to recalibrate any sensor that is moved!
|
