Screen Image

Explanation

This message can refer to any of the eight angle sensors on the Sidelifter.

The message only occurs during angle sensor calibration.

Causes

• Angle sensor is installed incorrectly
• Wrong arm or stabiliser selected set up with plumb bob
• Bottom arm may need to be recalibrated before top arm can be calibrated.

Operator Actions

• Use override code to continue operation

Service Tasks

Check:

• The angle sensor is bolted to the correct side of the arm or stabiliser and that the orientation is correct (i.e. wire pointing upwards)
• The angle sensor selected on the display menu corresponds with the arm or stabiliser that has been set-up with the plumb bob
• If difficulty is encountered with calibrating the top arm angle sensor, then try swapping it with the bottom arm angle sensor and recalibrate both.