Screen Image

25 = FRONT CRANE

26 = REAR CRANE

Explanation

Fault detected between Crane Junction Box and Stabiliser Angle Sensor

The Stabiliser Angle Sensor measures the angle of the stabiliser.

Causes

• Damaged sensor cable or connector plug
• Moisture in sensor connecting plug
• Faulty sensor

Operator Actions

• Check connector plug firmly seated and not damaged
• Use override code to continue operation
• Request service

Service Tasks

• Check sensor cable and connector plug.
• Replace the sensor. The orientation of the sensor is important and the cable should point upwards. Recalibrate using procedure SL0005.
• Check the calibration by hanging a plumb bob from the L-Pin and move the Stabiliser so that L-Pin is vertical to the H-Pin
• With the diesel engine not running but SMARTlift switched on, go to Manufacturers Area – View Pin Distances-View Front or Rear Pin Distances-View Horizontal Distance HL. The distance should be zero +/- 10mm.
• Remember, all angle sensors are the same component so it is possible to swap sensors in order to help diagnose faulty wiring or a faulty sensor. Just remember to recalibrate any sensor that is moved!