|
|
|
|
|
The system will detect common electrical faults such as wire breakages and short-circuits in the angle sensors, pressure sensors and the stabiliser deployed microswitch.
If the system detect a fault then a warning horn sounds and a screen message is displayed. The screen message will show where the suspect sensor is located. The location is indicated with a "*" symbol.
The system may also prevent certain functions used when a sensor fault is detected. To allow a lift with a faulty sensor refer to the manual override procedure.
The screen message below shows that the sensor on the front stabiliser down sensor has a fault.
The screen message below shows that the sensor on the front bottom arm angle sensor has a fault.
