|
|
|
|
|
Digital Control is included as standard on many models of Sidelifter.
The SMARTlift Load Monitoring System is part of the Steelbro commitment to stay at the cutting edge of Sidelifter design and technology. The system uses advanced electronic technology to enable intelligent control and improved Sidelifter safety.
SMARTlift Load Monitoring is available as an additional factory option, or can be added later as an upgrade to a Sidelifter model equipped with Digital Control.
The SMARTlift Load Monitoring system controls all crane and power pack electrical systems via two electronic controllers, one situated on each crane.
READ THIS SECTION BEFORE USING SMARTLIFT
|
The SMARTlift Load Monitoring System is NOT a fail-safe safety system. Its purpose is to monitor the load and to make the operator aware of potentially unsafe practices but it will not prevent these from happening should the operator continue with an action. SMARTlift is not a substitute for responsible operation and operator training. It is essential that operators follow safety procedures, making themselves aware of the operator manual and taking heed of the warnings and cautions contained in it. If in doubt, they should seek further training. It is essential that the system is properly maintained. In the unlikely event of a fault the owner must report this immediately to the service agent. Until the fault is repaired, the system cannot be considered fully operational. |
