If the lifting chains are stowed in the toolbox then fit these as follows:
On the remote control, select Legs, and place the feet on the ground
Select High speed () and raise the bottom arms to their maximum
For chains that use Clevis pins, attach the hammerlocks of the chains to the Clevis. For chains using an oblong link, fit the oblong link over the G pin on the end of the crane arm
Raise the top arms until the chains hang freely in the air
Check that the lifting lugs, which are left and right handed, are correctly positioned as per Lifting Lug Instructions. Ensure that the left and right lifting lugs are in their correct positions. If not, lower the top arm, and reposition. Raise the top arm and check lug position is now correct
Return the lifting arms to their stowed position ensuring the lifting chains are in the chain trays beside the twistlocks
Move each lifting module independently from the delivery position to the opposite end of its traverse. Clean down chassis surfaces along where the lifting module moves.
Allow the powerpack engine to idle for a minute after working at full power to allow a gradual rate of cooling
Shut down the engine by turning off the remote control or pressing any of the red emergency stop buttons on remote control box.
Turn off the key ignition. Remove the key if the unit is to be left unattended for any time.
) and raise the bottom arms to their maximum