Figure 1 - C-Pin Location
20 Aug 2010 PDF File |
Technical Bulletin |
Version 1 |
Author: Neil Savage |
The C-pin on all cranes of the SB121 family of sidelifter models has been changed in order to increase the clearance between the pin head and the gland of the bottom lift cylinder when stowed.
|
Figure 1 - C-Pin Location |
SB121, SB122 models in all markets will be affected when the change is fully implemented.
First used on serial number SB8703
Spare Parts:
C-Pin PN-32540 has been replaced by PN-39219
Figure 2 - Old pin PN-32540 |
Figure 3 – New Pin PN-39219 |
The old and new versions of the pin are not directly interchangeable although both can be used with a minor modification: See Use Instructions
The new pin design is located by a 10mm square mild steel bar (shown blue in figure 3) which has been added to the c-pin lug. If an old pin is used with a new bottom arm the square retainer bar will have to be removed or the pin head has to be cut down as shown in figure 4. If a new pin is fitted to an old bottom arm then a retaining bar will have to be welded to the lug as shown in figure 5.
|
|
Figure 4 – Modify old pin for use with new bottom arm |
Figure 5 – Modify old bottom arm for use with new C-pin |
N/A
NC-00189
