E0014 SB360 Stabiliser Down Diode Safety Retrofit System Microswitch Version KUWAIT ONLY

17 Aug 2004 PDF File

Version 1

Electrics

 

Refer to:

  1. Drill one Ø12mm and one Ø 32mm hole + four M5 holes in positions shown on S6-33177, in each stabiliser housing
  2. Install the microswitch assemblies.
  3. Run 6m of 4 core cable from the right (front) module junction box to the front microswitch. Run 6m of 3 core cable from the left (rear) module junction box to the rear microswitch. Note: In the rear microswitch common 14 and 22 inside the switch.
  4. Install contact blocks into module junction boxes and install block/relay assembly into main control cabinet.
  5. Test the system logic.

SYSTEM LOGIC

WARNING BUZZER AND LIGHT

NEW HELLA RELAY (NO)

NEW 4 POLE RELAY (NO)

TOP ARM UP

TOP ARM DOWN

BOTTOM ARM UP

BOTTOM ARM DOWN

BOTH STABILISERS TOUCHING THE GROUND

NO

OPEN

CLOSED (DIODES BYPASSED)

YES

YES

YES

YES

EITHER OR BOTH STABILISERS OFF THE GROUND

YES

CLOSED

OPEN (DIODES ACTIVE)

NO

YES

YES

NO